The Airflo PC is usually pretty tight unless heavily weared. joystick - ensuring it's properly centered - to avoid cursor drift. Decrease this value to require less joystick displacement-from-center Mouse Sensitivity, increase for more sensitive. than the first (in which case you'll also need to change the Joy1:: and Joy2::
If you have more than one Joystick, Increase this value to use a joystick other Pad Right Mapped to WheelDown Previous Weapon Right Analog Down 13 Mapped toĞ Peek Right Left Analog Down 12 Mapped to Q Peek Left
Left Analog Joystick Mapped to WASD Standard Run/Strafe Right Analog Joystick Mapped to Mouse Mouse Look on all my games) it may be screwy to you so modify the settings to your preference. These are my personal settings based off the Rainbow 6 layout (I use it (All # are imprinted on joystick buttons) this script is specifically desgined for the Nyko - Airflo PC it may be used with any It is based off the mouse script located on authotkey's website. This script converts the Nyko Airflow PC controller into a functional controller for
Since Nyko has no software avaliable to customize their controller I decided to Version 0.4 Alpha - General Gaming Layout PC Keyboard / Mouse Bindings Script for Nyko - Airflow PC, and Dual Analog Controllers still working on it but major bugs are gone. Yeah since I am releasing this script to the public I plan to make it much easier to configure, and what I had in mind looks much like what you suggested, thank you again course I was working on this script until early morning so I wouldn't be supprised to see a few things like that haha. Hahah I completely missed those GetKeyState command with the state variable, LOL. This avoids conflict/interference if you ever press down more than one button at a time. It's best to replace state with a unique variable name (e.g. Send, Push and hold keyįinally, because all variables are global, any time you have something like this: In the button section: you could replace the double colon with a single colon and make these other changes: In the config section (to make it easier to configure): If you want to make the script easier to reconfigure for a joystick other than the first, there is now a way to do that (I've been meaning to change the posted joystick script to do this too): If the speed at which keys are pushed down and released is important, this line near the top of the script will make things faster, though it might be too fast for the game to work reliably (especially if you use -1 vs. In addition to performing a little better, there will be less delay because KeyDelay will be done only once: You might already know that things like the below can be simplified as "Send, m". I thought it might be seen as two, but if I'm reading the script right, they map the other stick onto some of the other remaining axes. I guess your controller is seen as only one joystick after all. For assistance with the drivers, please contact the developers.That's a very elaborate script, nice work. Although they are tested and fully supported by the game, Feral cannot offer support with the installation or operation of drivers.
The devices below require third-party drivers that are not written by Feral. These devices will be recognised by the game but do not have enough buttons or analogue controls to support all the possible in-game controls, meaning some tasks may still require the keyboard or mouse.
For digitally-downloaded games, the manual can be found in the Documentation dropdown in the About tab of the LEGO Star Wars III: The Clone Wars pre-game Options window. They also have enough buttons and analogue controls to fully support all the in-game controls.įor information about the default controls, see the instruction manual that came with the game. These pads will work with the game without any drivers needing to be installed. Below is a list of pads that can be used with LEGO Star Wars III: The Clone Wars.